Dragons Hobbies Forum
Radio Control and Models => Tyco RC => Topic started by: stan on March 16, 2009, 19:58:24
-
i own a hi jacker always have since i was a tiny lil toddler afew years unage.
but all the wires came lose and im trying to fix it to get it rnning again...if some one can et me some pics of the bottom side of the cicuit board where all the ires are that woul be great
-
Look closely on both sides of the board, the wire colors were often printed on the board.... blk, wht, red, etc.
-
Look closely on both sides of the board, the wire colors were often printed on the board.... blk, wht, red, etc.
yes but theres 2 of each color printed on the board and theres 2 red 2 -3 green 2 yellow 2 white.... and no wires are connected so u see my delema?
-
if you can post up a picture up your curcuit board, I think I can help you.
-
mmk here you go
-
Well, I'd need a bigger, higher res picture then that to see the clues.
So looks like the servo is still hooked up? Just need to know where the motor and battery pack hook up?
-
only half the servo whires are hooked up, i need to know where the batter placement will be the motor and the on off switch and those are basicly all the same color, i tried putting a high res pic up but it exceeded the pic upload amount, i can try posting it on an upload sever and putting the link down later when i get a chance