« previous next »
Pages: [1]   Go Down

Author Topic: Artillery Sidewinder X2 - 3D Printer  (Read 3946 times)

Dragon

  • Administrator
  • Platinum Level
  • *****
  • Posts: 4865
  • Have you played my board game?
    • Rival Troops
Artillery Sidewinder X2 - 3D Printer
« on: October 24, 2023, 18:34:33 »
For my birthday I got a new 3D Printer, the Artillery Sidewinder X2. The instructions in the manual that came with it was pretty good, but still left some stuff unmentioned that I wasn't aware of beforehand. I found a great video on YouTube that helped out.

https://youtu.be/9JZqosMxmxk?si=tl2ciPbzQ4waqg4X

Thanks to Just Vlad for this. Check out his channel at www.youtube.com/@Just_Print
Logged
"Hello IT. Have you tried turning it off and on again? ... OK, well, the button on the side. Is it glowing?... Yeah, you need to turn it on. Err, the button turns it on. Yeah, you do know how a button works, don't you? No, not on clothes." - Roy (The IT Crowd)

Dragon

  • Administrator
  • Platinum Level
  • *****
  • Posts: 4865
  • Have you played my board game?
    • Rival Troops
Re: Artillery Sidewinder X2 - 3D Printer
« Reply #1 on: December 12, 2023, 20:48:46 »
I just came across another video which explains more about bed leveling for the 3d printer - https://youtu.be/oX4up29xUuw?si=ggRse729SdsdzAo1 . I'm glad I found this today because I've been noticing that sometimes it's difficult to get a model starting to print and I was thinking I might need to readjust the bed.
Logged
"Hello IT. Have you tried turning it off and on again? ... OK, well, the button on the side. Is it glowing?... Yeah, you need to turn it on. Err, the button turns it on. Yeah, you do know how a button works, don't you? No, not on clothes." - Roy (The IT Crowd)
Pages: [1]   Go Up
« previous next »